Perfectly protected against the sun – the first clear UV protection for the outdoors!
All resins / woods turn into ambra colour over time, but UV-Protection Oil has been developed to maintain the epoxy’s clear colour and slow the yelloying process by (UV factor) 12 times in comparison to untreated epoxy.
Ideal for rivertables, epoxy furniture, exterior design objects, windows, doors, cladding, fencing and other structured joinery.
Natural oil-based and microporous finish does not crack, flake, peel or blister. Water and dirt resistant, moisture regulating and reduces damaging.
Description
Clear, satin wood finish based on natural oil for wood in outdoor areas. Microporous surface allows the wood to breathe and reduces swelling and shrinkage.
Water-repellent, will not crack, peel or flake. As top coat on already colour treated wood, Osmo UV-Protection-Oil Extra prolongs the renovation intervals significantly. As a single product application, it blocks the greying process on vertical surfaces with a UV protection factor 12 in comparison to untreated
wood when two coats are applied. Osmo UV-Protection-Oil Extra is furnished with active ingredients to protect the coating against mould, algae and fungal attack. Simply apply without sanding. Easy and seamless application. Finish stays workable while coating.
Recommended use
Osmo UV-Protection-Oil Extra is ideal for all vertical wood surfaces in outdoor areas: doors, windows, window shutters (dimensionally stable elements), carports, timber cladding, balconies, fences, pergolas, and summer houses (dimensionally unstable elements). Also suitable for bamboo poles (e.g. in screens).
Ingredients
Based on natural plant oils (sunflower oil, soya oil, thistle oil and linseed oil), siccatives (drying agents) and additives, biocidal active ingredient: Propiconazole. Dearomatized white spirit (benzene-free).
EU limit value for this product (cat. A/e): 400 g/l VOC (2010).
This product contains max. 400 g/l VOC.
Detailed declaration of ingredients available upon request.
Storage
Up to 5 years and longer if can is kept dry and closed tightly. If thickened by frost, store for 24-36 hours at room temperature before use.
Surface preparation
Wood surface must be clean, dry and frost-free (moisture content max. 20%). Osmo UV-Protection-Oil Exra is ready to use. Do not thin. Stir well before use.
If possible, please apply the first coat to all sides before installation. Fresh wood, containing natural wood extractives and especially hard wood needs to weather off (for approximately 6 weeks) after installation. Thereby the wood becomes absorbent and the wood finish adheres optimally.
A coloured base coat is recommended, e.g. Osmo One Coat Only, Natural Oil Woodstain or Country Colour.
For renovations, clean old microporous wood finishes thoroughly. Degrey any already greyed wood withOsmo Wood Reviver Power-Gel before applying Osmo Clean old microporous stains thoroughly. Old paints and lacquers must be completely removed.
As a general rule, wear a dust mask during sanding works. Do not sand smooth surfaces finer than P120.
The finished surface is influenced by several factors, including the condition of the wood. Therefore, a trial application is always required, especially for unfamiliar
surfaces.
If additional protection against blue stain, rot and insects is desired, pre-treat the wood if possible on all sides with Osmo WR Base Coat.
Technical data
Specific gravity: 0.9-1.0 g/cm³
Viscosity: >50s DIN EN ISO 2431/3 mm, viscid
Odour: faint/mild, odourless after drying
Flash point: >60 °C acc. DIN EN ISO 2719
Documentation
Reviews
There are no reviews yet.